New Build RM01X with Mazda 787B No.56 Body
Had to build the RM01X!
was a good built and had to have a good body for it so i choose 787B No.56 ;-) (even cut air vents and wiper)
almost there, still figuring out if i do a shelf or runner!
No. 56 font is a bit small, need to find a right size, also white mazda speed logo for the wind visor .. I think i should buy a decal printer!!??
the stock RM01 is wonderful to run!!
Chassis Mods :-
Kyosho Wing Stay
Kyosho Diffuser
Tamiya 380 Sports tuned
380 Heat Sink with Fan
VSC ESC to be installed
SR3100
Hitech low profile servo
Straut bar between the front axle to be installed.
If you liked those pictures, you should see these...
RM01X for my 58006
Comments
sidewaysdave69
very nice! I had an old group C 787b fantastic looking cars.
matman
Looks great & the chassis is fantastic too build . I have two of these fine RM01X's & the RM01 + spear dody sets . So your not sure if you are going to run it ?. I would like too know they run & i don't have any where to run mine .
You have done a fantastic job & look great .
pininy
I would run the rm01x chassis, but use the no.18 shelf would be nice to run it at least once. The kyosho wing stay is very stable even under corners! And the diffuser kicks up dirts!!
Porsche959Boy
I'm a gig fan of the RM-01... what type of battery will you use... NiMH or LiPo? Also, what type of ESC?
pininy
tamiya's shorty life, venom esc they are pretty good.
Fernado Alonso
Cool !!!!!! Ride's mister
Cheers,Alex
Want to leave a comment?